1 Be fore you start to install the system, we recommend to attach small nails where the eyes will be installed, and run strings between them to make sure you are happy with the pattern.
2. When you are satisfied with the pattern, drill the hole and install the eyes, see instruction for different materials.Concrete, Weaker substances such as brick block and stone
3. Thread the wires through the eyes in the same way as you did with the strings, to create the trellis system.
4. Attach the end fittings.
5. When you install the second wire try to weave the wire into the first one by alternating between going over and under the first wire. This will minimise need for cross clamps.
6. When both wires are installed, tension the wires at the adjuster units.
8. If using cross-clamps install these last, after tensioning the system.
note:
The cross clamps funktion is to stabalise the system at the crossings of the wires.
This is mainly needed if the wall span is more than 2meters and/or the plants are heavy.
|
Installation